Простая кожаная сумка своими руками

24
vOFF4ik
vOFF4ik78432189

    Simple Leather Bag Leatherworking
    Index of operation and materials:
    0:02 2mm (0.08inch) thick leather
    0:40 Cut plywood pieces to make the wet forming mold for the two sides
    2:12 Forming leather with vise pressure
    3:04 Contact Cement (Contact adhesive)
    4:00 Trimming sides flush with main leather piece
    4:28 Beveling tool used every time a cut is made to break the corners of the leather
    5:04 Dyeing edges with brown leather dye, rubbing it on also makes the edges smoother
    5:27 Fork punch used to mark stiches position
    5:45 Holes are then drilled with 2.5mm Bit
    6:25 Stitching with waxed thread going over the border for extra fancy look
    7:11 Cutting front to size and shape
    7:30 Make two ring out of 4mm round brass stock
    8:30 Also badly soldered the ends, pretty sure it’s not needed since brass work hardens very quickly, I can’t bend back the rings
    12:00 Shoulder belt parts, I could have made it out of a single piece if I had one long enough.
    13:04 Grooving tool to add decorative grooves
    13:50 Puch holes for the lock loop
    14:00 Small strip of the same leather rounded with sandpaper and dyed
    14:18 Olive Wood Burl, cut to size, sanded square on the 2x72 belt grinder, drilled with 2.5mm bit and ground to shape again with the 2x72 belt grinder
    14:54 Groove for the thread to sit in carved with chisel
    15:08 Boiled linseed oil as finish
    15:50 Alcohol is used to rub off some of the finish of the leather, with the help of fine steel whool. I like the look of the leather much more if it’s not uniform
    17:04 Marking with the hot branding iron I made a while back
    Off camera I applied matt leather finish all over the bag.

    Комментарии

    Для добавления комментариев необходимо авторизоваться.